Unitech PA970 User Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
The Unitech PA970 is certified in the U.S. to conform to the
requirements of DHHS/CDRH 21CFR Subchapter J and to
the requirements of IEC 825-1. Class II and Class 2
products are not considered to be hazerdous. The PA970
contains internally a Visible Laser Diode (VLD) whose
emissions do not exceed the maximum limits as set forth in
the above regulations. The scanner is designed so that
there is no human access to harmful laser light during
normal operation, user maintenance, or during prescribed
service operations.
CAUTION - The use of controls or adjustments or
performance of proceduyres other than those specified
herein may result in hazardous laser light. Use of optical
instruments with the scanner will increace eye hazard.
Optical instruments include binoculars, microscopes, and
magnifying glasses. This does not include eye glasses worn
by the user.
The laser safety warning label required by the DHHS/IEC for
the PA970’s optional laser scanner module is located on the
memory compartment cover, on the back of the unit.
Laser Scanner
7
1
Troubleshooting
If the screen is blank or the unit fails to turn on, charge the
battery for 16 hours. If the battery is fully charged and the
unit still fails to turn on, reboot the device by inserting the
end of an unfolded paper clip (or other similar blunt-ended
pin) in the reset hole.
Service and Support
http://www.ute.com
1 (800) 861-8648
9
1
FCC Statement
FCC ID: HLEPA970
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
2. this device must accept any interferance received,
including interferance that may cause undesired
operation.
1. This device may not cause harmful interferance, and
8
1
Notes
IMPORTANT
The PA970s Backup Battery arrives to the customer
switched off. Before charging the PA970, the Backup
Battery must be switched ON in order to avoid acci-
dental data loss.
Open the SD Compartment and flip the white switch
toward the stylus slot
.
This procedure is again covered in the “Charging the
PA970” section, later in this guide.
Page view 1
1 2 3 4

Comments to this Manuals

No comments