Unitech MS100 User Manual download pdf (Page 10)

MS100 Manual

Beep Tone

Select a value from “None” to “High” to set the loudness of the tone,

or select “Low to High” or “High to Low” to set the characteristic of

the tone.

Default is “Medium”.

Intercharacter Delay

Intercharacter Delay is the time duration between data characters

sent from the scanner to the computer. Intercharacter delay is

usually inserted when the data flow must be slowed down for the

benefit of a slower computer.

Default is “1 ms”.

Interblock Delay

Interblock delay is the time duration that can be inserted between

one block of data and another. This function is analogous to the

time duration required between dialing a phone number’s country

code and the phone number itself. The interblock delay can be

inserted via SCM’s Data Editing function (see page 22).

Default is “10 ms”.

Following is a detailed discussion of each of the settings, their

attributes, and the effects each of these will have on data output

from your Unitech scanner.

Settings

The only attribute for the “Device” setting is “Device ID”, which

defines the device to which the scanner is connected (usually a

computer or terminal). Select the setting that most closely de-

scribes your device.

The default selection is “01 - IBM PC/AT, PS/2 MOD 40, 60, 80,

USB”, which is appropriate for most PCs.

Device

The three attributes for “Beeps and Delays” are: “Beep Tone”,

“Intercharacter Delay”, and “Interblock Delay”.

Beeps and Delays

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 58 59

No comments

Unitech MS100 User Manual Page 10